Fortress Motion Detector

This article contains instructions for programming a Fortress Motion Detector with the S03 system.

NOTE: If you purchased the motion detector as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a motion detector separately, and are now adding it to an existing system.

Programming a Fortress Motion Detector with the S03 Main Panel:

1. Turn any other motion detectors OFF. Turn the motion detector that you are programming ON.
2. On the Main Panel, enter the following:
3. <your 4-digit password> #
4. 7 # <2-digit zone number> #
5. Trigger the motion detector by waving in front of the detector. Your panel will announce that the motion detector was added successfully.
6. On the Main Panel, press #.
7. Turn any other motion detectors back ON.

It's also a good idea to make sure that the Zone's attributes for the motion detector are set to Zone Type 5 ('Home'). To set a Zone to Zone Type 5, do the following:

On the Main Panel, enter the following:
<your 4-digit password> #
* <2-digit zone number>
2 5 #
#

Please note you can also change individual sensor attributes via the My Fortress mobile app on your smart phone by going to Management->Sensors->Sensors