Standard Motion Detector

This article contains instructions for programming a Standard Motion Detector with the S02 system.

NOTE: If you purchased the motion detector as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a motion detector separately, and are now adding it to an existing system.

Programming a Standard Motion Detector with the S02 Main Panel:

1. Turn any other motion detectors OFF. Turn the motion detector that you are programming ON.
2. On the Main Panel, enter the following:
3. <your 4-digit password> #
4. 7 # <2-digit zone number> #
5. Trigger the motion detector by waving in front of the detector. Your panel will beep twice.
6. On the Main Panel, press Return.
7. Turn any other motion detectors back ON.

It's also a good idea to make sure that the Zone's attributes for the motion detector are set to Zone Type 5 ('Home'). To set a Zone to Zone Type 5, do the following:

On the Main Panel, enter the following:
<your 4-digit password> #
* <2-digit zone number>
2 5 #
Return