Remote Fob

This article contains instructions for programming a Remote Fob with the S02 system.

NOTE: If you purchased the remote fob as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a remote fob separately, and are now adding it to an existing system.

Programming a Remote Fob with the S02 Main Panel:

NOTE: By default, the Remote Fobs use Zones 30, 31, and 32 in the S02 system.

1. Make sure any motion detectors are turned off before you begin.
2. On the Main Panel, enter the following:
3. <your 4-digit password>. #
4. 7. #. <2-digit zone number>. #
5. On the Remote Fob, press any key to add it to the Zone. You will hear 2 beeps on the Main Panel.
6. On the Main Panel, press Return.
7. Turn on any motion detectors that were previously turned off.