Panic Button

This article contains instructions for programming a Panic Button with  the Total Security system.

NOTE: If you purchased the panic button as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a panic button separately, and are now adding it to an existing system.

Programming a Panic Button with the Total Security Main Panel:

1. Turn off any motion detectors to prevent accidentally programming them.
2. On the Main Panel, enter your Administrator password, then press the Menu button [three horizontal lines].
3. Navigate to "Sensors", then select "Sensor".
4. Scroll to the desired Zone, and press OK.  You will hear "Zone # - Add."
5. Press the Panic Button to trigger it. You will hear "Add - successfully programmed."
6. Return to the starting screen using the Back button.
7. Turn on any motion detectors that may have been turned off.