Remote Fob

This article contains instructions for programming a Remote Fob with the GSM system.

NOTE: If you purchased the remote fob as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a remote fob separately, and are now adding it to an existing system.

Programming a Remote Fob with the GSM Main Panel:

1. Make sure any motion detectors are turned off before you begin.
2. On the Main Panel, enter your 6-digit SET password, then press Enter.
3. Press Enter to select Remote Control.
4. Scroll to the left/right to select the appropriate Remote Control #, if needed.
5. With "Coding" highlighted, press Enter. You will see a string of zeros appear.
6. On the Remote Fob, press any key to add it to the Zone.
7. On the Main Panel, the zeros on the screen will be replaced by some other numbers.
8. Press Enter to save your changes.
9. Press the ESC key until you have returned to the main screen.