Pet-Immune Motion Detector

This article contains instructions for programming a Pet-Immune Motion Detector with the GSM system.

NOTE: If you purchased the motion detector as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a motion detector separately, and are now adding it to an existing system.

Programming the Pet-Immune Motion Detector to the GSM Main Panel:

1. Turn any other motion detectors OFF. Turn the motion detector you are programming ON.
2. On the Main Panel, enter your 6-digit SET password, then press Enter.
3. Scroll to the right using the '6' key to select Zone, and press Enter.
4. Select an appropriate Zone for the motion detector. By default, Zone 2 is used for motion detectors.
5. With 'Coding' selected, press Enter.
6. On the motion detector, press and release the 'Code' button. The LED light will flash quickly.
7. Press and release the 'Code' button again.
8. On the Main Panel, a string of zeros will be replaced by another string of numbers. Press Enter.
9. Return to the main screen using the ESC key.
10. Turn the other motion detectors back ON.

See more about Zones in the GSM User Manual, Page 98.