Panic Button

This article contains instructions for programming a Panic Button with the S02 system.

NOTE: If you purchased the panic button as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a panic button separately, and are now adding it to an existing system.

Programming a Panic Button with the S02 Main Panel:

1. Turn off any motion detectors to prevent accidentally programming them.
2. On the Main Panel, enter the following:
3. <your 4-digit password> #
4. 7 # <2-digit zone number> #
5. Press the Panic button to trigger it. You will hear 2 beeps from the Main Panel.
6. On the Main Panel, press Return.
7. Turn on any motion detectors that were turned off.

It's also a good idea to make sure that the Zone's attributes for the Panic Button are set to Zone Type 3 ('Emergency'). To set a Zone to Zone Type 3, do the following:

On the Main Panel, enter the following:
<your 4-digit password> #
* <2-digit zone number>
2 3 #
Return